• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Differential Breather Bolt

Okie69

Contributor
Sr. Member
Joined
Nov 28, 2011
Messages
842
I’m getting ready to paint my rear housing and pulled my breather bolt and noticed it was completely clogged with sand. After cleaning it as best I could I still can only get a small amount of air through it by blowing through it. Should I be able to see straight through it or is it some type of metered orifice? Should I just go ahead and get a new one?
48422113-EA20-4375-92FC-1ADB0208CE42.jpeg
 

papy

Contributor
Sr. Member
Joined
Jun 13, 2012
Messages
905
just cleaned the one on my 79 yesterday. same as my 67 its juts a tiny hole juts enough to let the air escape as things heat up/expand
i would use a pipe cleaner with some solvent just to make sure she's cleaned out
 

NicksTrix

Bronco Guru
Joined
Aug 1, 2001
Messages
6,410
just run a 1/8 drill through it, get the build up out of it and put fresh longer hose on. good to go.
 

jamesroney

Contributor
Bronco Guru
Joined
Sep 11, 2007
Messages
2,607
Loc.
Fremont, CA
I’m getting ready to paint my rear housing and pulled my breather bolt and noticed it was completely clogged with sand. After cleaning it as best I could I still can only get a small amount of air through it by blowing through it. Should I be able to see straight through it or is it some type of metered orifice? Should I just go ahead and get a new one?

I just measured a couple out in the shop, and the hole is a "go" for a #51 drill. A 1/16 inch drill passes with clearance. Yes, you can see straight thru.

A 1/8 hole would certainly be superior. I've never understood why the vent port is so small (and easily plugged.)
 

NicksTrix

Bronco Guru
Joined
Aug 1, 2001
Messages
6,410
if anyone is curious, the thread pitch is 7/16-20 on the vent assembly and axle housing. i know that has been questioned over time.
 

Apogee

Contributor
Bronco Guru
Joined
Nov 26, 2005
Messages
6,348
Loc.
Tangent, OR
#51 drill has a Ø.067" diameter...I just ran a Ø1/16" through mine to clear out whatever was plugging it up. I've always assumed that the small hole prevents oil from backflowing up and out the vent, though one would think that the placement out on the tube next to the differential would prevent that. I've only had issues with failed ARB air seals pressurizing the housing and pumping oil out the vents.
 
OP
OP
Okie69

Okie69

Contributor
Sr. Member
Joined
Nov 28, 2011
Messages
842
Thanks for the reply’s guys. I just ended up drilling it out with the smallest bit I could find. Only way I could get it cleared up.

Got the housing painted too!
A0FFD8E2-892A-4FA8-B9A6-822B12D3D115.jpeg
409AA072-26C7-4340-80F9-35BF14C163C1.jpeg
0A431E74-C9FC-47F6-95EC-944741AD517B.jpeg
 
Top