Explorer

[bgduramax]

I'm getting ready to pull the harness out of a 96' explorer and was wondering what all to get. I have heard efiguy had a PDF, but can't find it anymore. Also, I'm very new to this forum so please be patient with me. Can anyone tell me how to reach out to efiguy?

 

[lars]

Simply put, everything you can. (going from memory...)

Start at the PCM connector at the top center of the firewall, then work your way around the engine compartment. Everything that connects to the engine. Charging system wiring. The fuse/relay box on the passenger side. The harness going back to the transmission, with its respective connectors.

Better to have a whole bunch left over than realizing eventually you missed something (been there, done that).

 

[bgduramax]

Thank you, that's what I was thinking. Buy chance do you have a way to reach efiguy to rework my harness and computer?

 

[dmoses42]

Here is his thread on reworking the harness and flashing the computer, should have his contact info as well:

https://classicbroncos.com/forums/threads/explorer-obd2-harness-re-work.257251/

 

[SLOWnEASY]

EFI Guy (Garry) email.
theefiguy@gmail.com

 

[Bruners4]

You don't need the front lighting that is in the harness going to the headlights and such from the PDB. I used a '97 donor and also grabbed all of the cruise control items.

 

[gnsteam]

May as well grab the inertia switch. Located on the passenger side kick panel area. And the OBDII port. Oh don't forget the ECU.

 

[73azbronco]

id buy a new inertia switch, just saying.

 

[904Bronco]

https://classicbroncos.com/forums/threads/mountaineer-explorer-5-0-swap.292774/

Read here ^^^^

 

[EFI Guy]

I think the pdf that you are referring to is my installation instructions. It's pretty recent and still sort of a work in progress. But, anyone who has one of my harnesses and has not installed it yet is welcome to reach out to me via email for it.

You can only fit so much information on wire labels, so it goes into more detail about how every circuit should be wired up.

I link to a picture in my canned email of where to make the cut on the firewall harness for removal.

BTW, excellent link Doug! I was not aware that thread existed.

 

[farmboy]

I think the pdf that you are referring to is my installation instructions. It's pretty recent and still sort of a work in progress. But, anyone who has one of my harnesses and has not installed it yet is welcome to reach out to me via email for it.

You can only fit so much information on wire labels, so it goes into more detail about how every circuit should be wired up.

I link to a picture in my canned email of where to make the cut on the firewall harness for removal.

BTW, excellent link Doug! I was not aware that thread existed.

I talked with you earlier about doing a harness for me on my 72 bronco with a 347 and 2001 explorer motor you send me options on the harness but lost it all on my computer it crashed