Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!

If you have problems registering or can't log into your account, please contact Admin.

Members

B RON CO

Contributor

Bronco Guru From Statesville, NC

Joined: Jun 29, 2016

Last seen: Today at 6:38 AM

Latest activity Postings Images Gallery Albums Garage items About

- B RON CO reacted to Steve83's post in the thread Rear brakes (both sides) dragging BAD with Like.
  
  Something is wrong on both sides because the secondary (front) shoe doesn't touch the anchor pin. That alone can "energize" the brakes...
  
  Oct 25, 2026
- B RON CO reacted to Bruners4's post in the thread Popped a freeze plug with Like.
  
  I have always used Permatex Aviation Form-A Gasket non-hardening #2 to seal expansion plugs into cast iron blocks. And also use brass...
  
  Oct 6, 2026
- B RON CO replied to the thread Rear brakes (both sides) dragging BAD.
  
  Hi, If you can post a picture of the brakes it might help. Make sure the parking brake cables are not frozen. Good luck
  
  Oct 4, 2026
- B RON CO replied to the thread RAT transmission install help.
  
  Hi, you didn't mention using a clutch alignment tool to line up the clutch splines with the pilot bushing. If you are 1" from the bell...
  
  Aug 16, 2026
- B RON CO replied to the thread Check out this strange cam bearing wear.
  
  Hi, I spun a cam bearing in an old Bronco many years ago. My machinist said to scrap the block because he couldn't guarantee the new...
  
  Aug 12, 2026
- B RON CO replied to the thread Rear Axle Seals.
  
  Hi, I would only change the seal that is leaking. Since there are different seals, I would bring the bad seal to Napa, and let them...
  
  Aug 12, 2026
Show older items
Loading…
Loading…
Loading…
Loading…
Loading…
Loading…

Members

Top