Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Oldtimer's latest activity
-
Oldtimer replied to the thread Bad Alternator?.That is the facory map lamp. My 68 had one, when I bought it in 73. -
-
Oldtimer replied to the thread Bad Alternator?.Paul, The OP had a 68 Bronco. @86Horn_EB_77 has a 72 Bronco, despite all the numbers in is user ID.
-
Oldtimer replied to the thread Bad Alternator?.I would change all the ADDED crimp connectors over to soldered connections with heat shrink insulation. Vintage crimp connectors arr...
-
-
Oldtimer replied to the thread Bad Alternator?.The RD/BK wire goes from ignition switch to starter relay, and nothing else. The RD/GR and PK wires are connected to same contact on...
-
-
Oldtimer replied to the thread How much does exhaust redo cost?.In front of rear tires is quite a bit louder for driver & passenger's.
-
Oldtimer replied to the thread Hand throttle cable length.Mine stays where I set it. There seems to be enough friction between the wire and the jacket to keep it in place, plus a half century of...
-
Oldtimer replied to the thread Stock radio conversion and repair.https://classicbroncos.com/forums/threads/stock-faceplate-bluetooth-upgrade.315236/
-
Oldtimer replied to the thread Brake Warning Light Testing.The lamp assembly does not need to be installed in dash to work properly. I would suspect the brake pressure warning light switch...
-
-
Oldtimer replied to the thread Brake Warning Light Testing.I would suspect ignition switch at this point. With key ON, and connecting PU/WH wire to ground, bulb illuminates. Power source, bulb...
-
-
I, have contacted Ingalls Engineering, about the Dana 44, 5 bolt steering knuckle to shim. We'll see if they reply.
-
Oldtimer replied to the thread Anyone know if the dashpad will fit with the Toms plate cage ?.Picture from their website, I would say yes. Does anyone have experience with stock defroster air flow and this front roll bar?
-
-
Oldtimer replied to the thread 500psi T-Bird Calipers.Link to braid-spreading tool was corrupted. https://www.summitracing.com/parts/rus-651970?rrec=true
-
Oldtimer replied to the thread Brake Warning Light Testing.Note: Ford design has prove out ground path from ignition switch passing thru plug at dual brake warning switch before it grounds the...
-
Oldtimer replied to the thread 1972 dash pad screws.However, if we go to the AMK Ford Fasteners catalog, they are definitely different shaped screws.
-
-
Oldtimer replied to the thread 1972 dash pad screws.They are "correct enough" for availability after 52 years :)
-
