• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Crazy idea? 2" BL, Warflares and 35's?!?!

SantaCruzBronco

New Member
Joined
May 9, 2010
Messages
27
Loc.
Santa Cruz
Glad I live in California!

Technically on a GVWR vehicle of 4,501-7,500 your frame height is only allowed to be 30" but I have never heard of anyone getting ticketed for that. And your body is not allowed to be mounted more than 5" off of the frame. But who runs a 6" body lift?

The one that people will get ticketed for is having your tires extend more than 2" from the body or mudflaps.

Otherwise there are no bumper height laws and no suspension modification laws. They also tend to look the other way on engine modifications on trucks (until you take it in for SMOG of course). Cops only really enforce engine modification laws on ricers.

And vehicles 1975 and earlier are SMOG exempt
 
OP
OP
XT700

XT700

Sr. Member
Joined
Apr 11, 2002
Messages
797
Loc.
Brownsville
Glad I live in California!

Technically on a GVWR vehicle of 4,501-7,500 your frame height is only allowed to be 30" but I have never heard of anyone getting ticketed for that. And your body is not allowed to be mounted more than 5" off of the frame. But who runs a 6" body lift?

The one that people will get ticketed for is having your tires extend more than 2" from the body or mudflaps.

Otherwise there are no bumper height laws and no suspension modification laws. They also tend to look the other way on engine modifications on trucks (until you take it in for SMOG of course). Cops only really enforce engine modification laws on ricers.

And vehicles 1975 and earlier are SMOG exempt

The number one reason for getting pulled over here is having tires that stick out past the body or flaps. You get two inches, we get ZERO!!! This is an easy one for law enforcement since the either stick out or don't, not much room for argument.
 

jamie

Full Member
Joined
Nov 30, 2008
Messages
207
i say put little tires on it to get it inspected. i did that with my big bronco down here in mass. i have a hook up down here if you want to get it registered in mass
 
OP
OP
XT700

XT700

Sr. Member
Joined
Apr 11, 2002
Messages
797
Loc.
Brownsville
i say put little tires on it to get it inspected. i did that with my big bronco down here in mass. i have a hook up down here if you want to get it registered in mass

Inspection stations are now noting the tire size of the vehicle when they do the paperwork. That way when you try to do this the blame falls on the vehicle owner not the inspection station. The place I have been going has been really good about giving me a sticker since the bumper height is legal and determining if the suspension is stock is debatable. However, he can't take much of a chance on losing his inspection number, I would guess most months it is the major source of income for many shops.
 

AWS

Sr. Member
Joined
Aug 2, 2004
Messages
596
Loc.
ST LOUIS
Here are a few pics, 2" body lift / 35" MT claws / bushwacker flares / stock rear springs / stock F150 front coils.
Steve
 

Attachments

  • PICT0050.jpg
    PICT0050.jpg
    148.8 KB · Views: 61
  • PersonalCamera 308.jpg
    PersonalCamera 308.jpg
    113.2 KB · Views: 62
OP
OP
XT700

XT700

Sr. Member
Joined
Apr 11, 2002
Messages
797
Loc.
Brownsville
Here are a few pics, 2" body lift / 35" MT claws / bushwacker flares / stock rear springs / stock F150 front coils.
Steve

Thanks for the pictures.

Does anyone know if it is possible to get springs with just 1-1/2 inches of lift? Probably be a custom order I would guess since none of the vendors list that size. Would love to stay with a 10 or 11 leaf spring in the rear and something flexy in the front.
 

ep67bro

Contributor
Bronco Junky
Joined
Aug 28, 2008
Messages
3,873
Loc.
Easton, MD
I thought New Hampshire was (live free or die!) so much for that idea!!!

Is there a classic or antique vechilce tag you can get so you do not have to inspect it? Most states have that option for cars pre 1975 or like here in Maryland any thing over 25 years old.
 

br0nc0xrapt0r

Loves pickles
Joined
Sep 28, 2007
Messages
5,439
you always could get some soft flexy springs for the rear "11 pack leaves" and do a 3.5 coil bucket drop on the front so it's lower but you still have the spring travel. If you do the coil bucket drop clean enough I doubt they could tell.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
looks more like its a bumper hieght issue than a suspension issue. I dont see anything that prohibits suspension mods.
The vehicle will be rejected If
(3) The suspension has been altered, and the bottom edge of the horizontal bumper bar:

a. Is less than 16 inches or more than 20 inches above level ground on a passenger vehicle;

b. Is less than 16 inches or more than 30 inches above level ground on a multipurpose passenger vehicle; or

c. Is less than 16 inches or more than 30 inches to the bottom of the front or rear frame rails of a light-duty truck, measured where the bumpers would be attached by the manufacturer;
I'd think you'd be ok as long as they dont consider you a passenger vehicle. I would go with some type of suspension lift and at worst you may need some type of drop bumper. Either that or you just drop down to 33's
I just looked at virgina's laws and they consider broncos passenger vehicles and the max bumper height is 22in.

For 1 1/2in of lift you might try f150 coils and rear blocks not the best ride but it does get you there. I still think you would get by with 3.5in of lift
 

daninghram

Jr. Member
Joined
Feb 10, 2010
Messages
66
I know southern NH is MUCH tougher than up north here, but I would not sweat it too much if you drive normal. Other than DMV enforcement, most cops would just check bumper height. I put antique plates and everything I can, the bronco was $16.50 for reg.
I think they draw less attention too. exhuast needs to be stock too and alot of people have nonstock . The bigger problem is now if your rigg fails inspection the station needs to report you to the state.
 

4lofun

Sr. Member
Joined
Mar 6, 2007
Messages
953
i live in s. NH.... 3 1/2 sl, 2 bl,, 37" tires. have gotten an inspection sticker for 3 years and not a problem with the law... bumper height 30" is all they know where i go... and besides , i would drive without an inpection if it came to it !!!!! you cant live free ANYWHERE !!!!!!!!!!! NH is talking about changing the motto any ways. not sure what, but being close to the MASS HOLES. NH will be the next nazi state... we write the laws and do what we want to... registration went up atleast $ 40 this year, cars, trucks, boats, atvs, snowmobiles, we all get the raise/
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
My 73 was orginally a NH bronco. Now out here in AZ the only lift requirement is that you run mudflaps. Very few people do though but I have know a few guys that got tickets for no mudflaps.. Heck we rarely have mud here.
 
OP
OP
XT700

XT700

Sr. Member
Joined
Apr 11, 2002
Messages
797
Loc.
Brownsville
Thanks for all the replies, going to run it for now and deal with any DMV issues down the road. May need to get some leads on inspection stations next time around.

Not planning on moving, I think we can all find fault with the state we live in and any of the others but I've been here for 37 years and really can't complain too much. Like many places if you are a native(or almost) than you blame it all on the newcomers/flatlanders. That is certainly what has happened here in my opinion. They move up here to enjoy the scenery, be it mountains, open fields or whatever but once they get here they don't want you to use the land or continue to farm in a way that they don't approve of. My flatlander neighbors from southern New England are a prime example, they bought land here to build on because of the beautiful fields and views but kicked out the farmer who was tapping their maple trees because the tubing is unsightly. Clueless morons!!! How do they think people make a living?? Sorry to rant headed back out to the garage for some more Bronco therapy.

Thanks, Walt
 

SwedenBronco

Jr. Member
Joined
Jun 14, 2009
Messages
110
Loc.
Gothenburg, Sweden


This is with Warflares and 1,5 inch blocks in the front, no lift rear, just stock heavy duty springs, tire size is 35x14.50-15 Pitbull Rockers.
There is some minor cut away on the inner fenders
 
OP
OP
XT700

XT700

Sr. Member
Joined
Apr 11, 2002
Messages
797
Loc.
Brownsville


This is with Warflares and 1,5 inch blocks in the front, no lift rear, just stock heavy duty springs, tire size is 35x14.50-15 Pitbull Rockers.
There is some minor cut away on the inner fenders

I like the look of that, won't be disappointed if it comes to having to do something along those lines. Thanks for the picture.
 
Top