CO Takeoff Saginaw pump

[pbwcr]

Saginaw Pump
This unit was detailed by Red Ram. It was for a combo Hydroboost and ram cylinder.
Comes with both cans one for external reservoir and the other with stock return line..
It has a bracket attached for a Windsor motor
Price is $100 including USPS shipping
Very low miles on it because I went another direction
I also have a collection of various brackets that are available for the cost of shipping only

 

[ET]

Can you elaborate more on detailed by red ram and is the output fitting included?

Thanks,
Eugene

 

[pbwcr]

Sag Pump details and more

The stock Sag Back has a 3/8” rubber hose fitting for the return and provision for the stock high pressure fitting that would be used after removing it from the aftermarket can. I assume you know that all Sag pumps use the same high-pressure fitting.

The aftermarket can has an AN–10, 37 deg male fitting for the return.
The high-pressure connection is “Aeroquip FBM 1144 hose end” and has the required sleeve. (ready to use with your Aeroquip TFE AN-6 braided stainless hose). I have unused hose (3’) for another $ 20 and spare sleeves. BTW, various FBM fittings can be used on the Saginaw without using an adapter. They come with various angles. The FBM 1144 cost 18.97 plus shipping and is included with the can. I will substitute an FBM 1138 - your choice.
The reservoir that mates with the aftermarket can shown below can be purchased for $25 including shipping. It comes with the female AN-10 and bracket to mate with a Sanden AC Compressor.

 

[ET]

Thanks. I sent you a PM.

 

[pbwcr]

Can you elaborate more on detailed by red ram and is the output fitting included?

Thanks,
Eugene

== ==
Way less expensive than my pump.
So if all you want is fittings or adapters. The result is you do not need the pump I advertised.
I have the conversion adapters from O-ring style to flare fitting style. This allows the old ham spam to have flare fitting like the late model Sag pumps. They come in two orifice sizes, and I am sure you want the large orifice. The adapters are new and unused.
What say you?
PaulW

 

[pbwcr]

== ==
Way less expensive than my pump.
So if all you want is fittings or adapters. The result is you do not need the pump I advertised.
I have the conversion adapters from O-ring style to flare fitting style. This allows the old ham spam to have flare fitting like the late model Sag pumps. They come in two orifice sizes, and I am sure you want the large orifice. The adapters are new and unused.
What say you?
PaulW

=== =
Did I lose your reply?
I will mail you the two adapters shown and you can mail me $10 if you want them instead of buying the Sap pump.
Regards, PaulW

 

[ET]

=== =
Did I lose your reply?
I will mail you the two adapters shown and you can mail me $10 if you want them instead of buying the Sap pump.
Regards, PaulW

No. I want to buy the whole setup, pump,bracket and pulley. I just wanted to know what type fitting on that pump and I don’t want to buy theadapter fittings. I don’t need the other reservoir since I have a remote reservoir. If you give me your address, I can send the payment.

Eugene