• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

newer block no hole for clutch bracket

GubNi

Sr. Member
Joined
Oct 31, 2004
Messages
481
Loc.
Northeast TN
I tried to bolt up the little bracket on the bellhousing to the block that the clutch rod pivots on and there's no hole in this block. Should I try to drill and tap it or just weld the bracket to the block? Is there an adaptor?
 

crawln68

Bronco Guru
Joined
Oct 8, 2004
Messages
3,045
Or you can convert over to a hydraulic clutch. That's what I did and I really like it.
 

DonsBolt

Bronco Guru
Joined
May 5, 2005
Messages
5,249
Loc.
Chestnut Hill, Mass
I have the Wild Horses bracket on my truck, It works awesome. You have to slightlly open up the hole where the bolt goes through. It would be a lot easier to open up the bolt hole before you install the engine, but it can be done with the engine allready installed.

Don't ask me how I know that%)
 

eds66bronco

Bronco Guru
Joined
Aug 3, 2004
Messages
1,119
Loc.
Essex, Vermont
i just welded a tab onto the stock bracket and drilled it so the bellhousing bolt held it in pace.
 

Attachments

  • ClutchBracket1.jpg
    ClutchBracket1.jpg
    58.4 KB · Views: 77
  • ClutchBracket2.jpg
    ClutchBracket2.jpg
    102.4 KB · Views: 96

BwoncoHowie

C-4 Wizard
Joined
Nov 11, 2002
Messages
3,571
eds66bronco said:
i just welded a tab onto the stock bracket and drilled it so the bellhousing bolt held it in pace.
Sorry, dont mean to hijack but... Hey eds66bronco!
Where did you get that clutch lever pushrod? I have been looking for one of those threaded hex type cones forever!!! ?:? :cry: :-X :-[ %)
 

ChrisinWV

Bronco Guru
Joined
Apr 1, 2002
Messages
1,372
Loc.
St George Island, MD
I bought a real pretty powder coated (read expensive!!) conversion bracket from the mustang crowd before the Bronco vendors started offering one.
It will be available at a much reduced price now that I am going hydraulic with the ZF.
 

FerrumCampitor

Sr. Member
Joined
May 2, 2005
Messages
761
Loc.
Hutchinson, MN
eds66bronco said:
i just welded a tab onto the stock bracket and drilled it so the bellhousing bolt held it in pace.

I did something very similar. Only I used a thin gauge metal strap and bent it around to the bellhousng. Works like a charm and didn't cost a thing.
 

eds66bronco

Bronco Guru
Joined
Aug 3, 2004
Messages
1,119
Loc.
Essex, Vermont
BwoncoHowie said:
Sorry, dont mean to hijack but... Hey eds66bronco!
Where did you get that clutch lever pushrod? I have been looking for one of those threaded hex type cones forever!!! ?:? :cry: :-X :-[ %)

that was on my truck when i bought it. it was for the 6 cyl 3 speed tranny and i just reused it when i put in the 5.0. sorry, that's not much help.
 
Top