Search results

I just installed a new speedometer and all my gauges are topping out(fuel shows full..oil pressure very high etc.) what might be my problem?

die cast has anyone made a half cab die cast?

I have the spring issue of LMC truck(bronco) magazine , and on the front cover is an orange /white half cab....I was wandering if anyone knows what make of rollbar is in the Bronco?....most of the rollbars for halfcabs ive seen seem to stick up to high....I just like the way this one sits low ...

good deal...I would like one

I had new hinges put on my bronco and the guy said he needs to loosen the strikers to adjust the door so it will close good( he builds street rods so i assume he knows what hes doing) any ideas on how i can get these loose? He said he tried an impact driver and they just want budge

fast eddie...I can not find a part number for a screw-in for a 302?

dip stick o1dudley...do they make dipstick that screws into the pan? thats how mine is made

how is everyone routing the oil dipstick with headers?

I sure don't...sorry

flares mine are cut and welded in

hinges are hinges still available? if so , whats your bottom dollar?

8's for me

broncoandy...pm sent

do the lift off hinges fit pretty tight?

welded in front flares

lets see some pics of Broncos with some stainless door hinges...im in need of some new hinges and was thinking about goin with stainless...no paint left over....do you think they will look ok on my bronco?

im looking at buying a floor mat for the half cab, not wanting carpet....who makes the best fitting floor mat?...thanks

thanks Justafordguy....I did end up taking the carb apart...looked like the fuel filter wasn't doing its job...cleaned up carb and put on a new fuel filter...everything is good now...thanks again

I have a '71 bronco...302, small cam , edelbrock 600 4barrel..my vehicle ran fine yesterday, today I was gonna take it for a ride...engine cranked right up, revved good, but want idle....ive checked for vacuum leaks, fuel filter and a few other things.....recent tune up....but im stumped , what...

sharp!!!...kbuck1