Search results

My question, do i need two panels?? One for constant power circuits and one for switched power circuts that only get power when key is on. The stock panel has both. The genaric Amazon fuse panel only has the constant power option. Thanks

Does anyone know the part number for the outside axle seal on a Dana 30. Thanks

Was using the stock 5 blade fan, for the most part it worked fine. My set up has aluminum heads, intake and long tube headers. The aluminum heads and headers disapate heat faster. That heat was trapped in the engine compartment at slow speeds causing fuel problems. I installed a 3000 cfm...

So the 2 1/2 lift project is completed. Here are the highlights. Starting in the back, Tom's 2 1/2 lift leaf springs. They were way to stiff after installing so pulled them out a removed the bottom two and #7 leaves. That got me the exact ride height and stance i wanted. It also softened...

So during my restoration this item was found in the glove box. I cleaned it up, detailed it but have no idea where it goes or what its for. Thoughts

I am interested in the correct gas line plumbing for a Sniper Efi on a Bronco with dual tanks. It certainly must be more complicated considering both tanks will need separate fuel pumps. I guess the fuel tank switch can be used to turn one pump on and the other off. I have tried 3 different...

How important is an adjustable front stablizer bar with 2 1/2 inch lift. I just had the toe set and caster measured but nothing was mentioned about the stablizer bar and diff position. Thanks for any advice.

Just got back from alignment shop after having the toe set. Have 2 1/2 lift 31 inch tires stock radius arms 2 degree bushings. My caster is -.5 degrees. The tech said you never want caster as a negative reading. Should i put a 7 degree bushing kit in or extended arms and 2 degree bushings.

My 69 Bronco has kind of a wierd option. Looking through pics i see lots of dash pics but very few with a throttle. My 69 has a throttle. Why it has this option i do not know. There is no PTO for a winch. Any one have any ideas why and if its a rare option.

Why is horn wiring such a mystery. I added a tilt sterring column horn switch and custom steering wheel. The horn has never worked. Infact on my 69 it is the only electrical component that wont work. What is the secret ???. i can make it work with a simple push button switch, but not with the...

Nice 1 gen Bronco on an episode i saw last week.

Stayed with the stock look. Added 30" of 1/4 steel between the frame rails ln the inside of bumper a hitch reciever for bike carrier or light utility trailer. Put in a couple led flush mounts for real light when backing up. Also strengthened the areas where the bumper attaches to the frame and...

There must be a solution to a softer rear suspension for vintage Broncos. I put in soft ride 2.5 lift rear leafs from Tom's. I may as well of put in a steel bar. The ride is horrific no suspension travel at all is how it feels. Completely ruins the drivability of the truck. There must be...

Just wondering if anyone else has had trouble with the CI pods speedometer. The included speed generator is very simple with only three wires, power, ground and a wire speedometer. Their instructions say to make sure you have signal to speedometer before calibrating. The problem is there are...

Stressed leather door panels, simple inexpensive mod that looks good.

First try at bumper build with 12000lb winch. Just tacking and final fitting. 1/4 steel plate laser cut. Will post finished pics when done.

Who sells the panel from the upper rad support to grill. Thanks

Front sway bars are getting quite pricey. I am interested in the performance achieved vs cost. How many members are using these and what are the comments with respect to enhanced safety and ride experience. Thanks.

20X57 storage rack 8" opening