Search results

The rear quarter panel of my newly acquired Bronco has a bend in it. It looks like something caught the bottom edge of the panel and pulled it outward. What would be the best way to bend it back into shape? Below are some pictures of what I’m up against. Thank y’all in advance for your time...

Price drop to $15,000 obo

More pictures

More pictures

This is my 1975 Ford Bronco with vin U15GLV67413. It is equipped from the factory with a 302 V8 and C4 automatic transmission. I purchased this Bronco about a year ago and have done quite a bit of work to it mechanically, but it is in need of body work. Below are the details. If you have any...

I am looking for any pictures or opinions of the Duff or Roma's trail doors. I like both, but would like to know the opinions of those who own either. Also, any pictures of them installed. Thanks, Joe

Thank you all for the help and advice. After studying the wiring diagram and removing one component at a time, I found my alternator to be defective. I installed a new one today and am back on the road with no more sparks when the battery is connected. Joe

It's a 1975 with a 302, automatic, no mods. I'll study the wiring diagram.

A couple of weeks ago, after driving my ‘75, the engine would not quit running after turning the truck to off. The gauges would go to rest, but the the engine would not stop, even by disconnecting the positive lead of the battery cable. After searching, all leads seemed to be a bad ignition...

I am looking for the bolt size that mates the D20 to the C4. Thanks, Joe

I am looking for a full top in the Jackson or Hattiesburg area. I could travel further. Joe

Thank you all for the replies, I appreciate it. Joe

That's the part. What does this part stop against in the transmission case?

While trying to remove the nut that holds the kickdown lever on my C4 to remove the neutral safety switch, I put to much pressure on the nut, something snapped, and now the whole lever flops around. Am I in for a major set back getting this repaired or is this easily repairable. Joe

Sent you a PM

I have a full hardtop for a classic Bronco. The top is complete, but will need some cosmetic work. It doesn't have any major rot, but does have some dents in the top and also on the passenger side which can be seen in the pictures. All the glass is good. Please message me with any questions...

Price reduced to $8,000.00 or best offer

I'm motivated to sell my Bronco and will take the "firm price" off the table; I'm open to reasonable offers.

I'll get some pictures to you tomorrow. Joe

A few more