Search results

If I remember correctly I had to use a #4 Philips tip and and a manual impact screwdriver. The kind you hit with a hammer. After soaking the backside (in the wheel well) with PB Blaster

Interesting story on how Vintage Bronco in Georgia is putting vintage Bronco panels on a new Bronco and selling them as "Modern Classic." Ford is suing them for "misleading" customers because they're calling modern Broncos "Vintage"

Timely post. Just ordered, thanks!

I might run a bead of clear and then spread it along the whole bottom. You don't want anywhere where water could get in and have a hard time getting out.

I believe mine has seam sealer there instead of the rubber gasket. The other issue I see is your entire window frame looks like it's sitting too far back. The hinge should be sticking out past the metal it's sitting on (see my picture above) So if everything is lining up now, I wouldn't...

Purchased these off Amazon but they don't seem to be available anymore there. Work great. I do see them on Ebay now for about 1/4 of what I paid for them. KBD Premium Seat Heater Kit High/Low Switch Settings Faster Warm Up (2 seat)

I bought Tom's seats, and blank steel panels for the doors and quarters and sent them all (after drilling holes for the door mounting springs) to my upholsterer and had them done in Italian leather. Then I mounted the factory door pulls and window crack. The rear panels are held in place with...

Or you installed the clutch release bearing incorrectly (or it's the wrong bearing) and it's already depressed the fingers on the clutch when you tightened everything back up. Put it in gear, pull the coil wire out, and turn the key. See if the clutch is engaged or not. If the motor turns...

Matte or Flat black to just slightly contrast the body's gloss, but it really depends on the wheels for me. If you have black wheels, then the flat black. If you have alloy/silver/chrome wheels, then Argent. If you have white wheels, then go with whimbledon white.

Perris, CA about 11 am today. Eastbound Van Buren after turning left from Southbound Washington St.

Sorry if already posted, but picked this up at Sam's Club today and they were low on stock. Came with tags that said official license from Ford.

Bronco frame flexes which leads to this problem. It's why I went with a copper radiator. More resistant to flex cracks and easier to fix on the trail/road.

From a 1979 McDonalds commercial briefly shown on a current History of Filet O Fish video.

You didn't say which ZF5 trans you have as the first gear varies and will make a difference on your choice of tires. 1st 2nd 3rd 4th 5th Reverse ZF S5-42 Close 4.14:1 2.37:1 1.42:1 1.00:1 0.77:1 3.79:1 ZF S5-42 Wide 5.72:1 2.94:1 1.61:1 1.00:1 0.77:1 5.24:1 ZF S5-47 Close 5.08:1...

The whole roof, or just staggered placements ?

It's really has more to do with the mechanism behind the button. I had new door seals and once I got hold of repo handles that had the rounded tip and the higher leveraged/reinforced lever that was an exact copy of the original, it worked like butter. Someone suggested swapping out the...

I'd have to actually finish my Bronco first. It's close....... It's little details like this that take months to do that keep dragging it out. :rolleyes:

So jealous.......

I'll talk about the mirror housing and the mirror itself just for reference for others. The mirror housing is tightened with the screw that's on the back of the arm that attached to the door. Either the screw is loose or you're F'd because it's held tight against the arm with a ball mount. If...