Search results

I am looking for a set of Dana 44 knuckles for my 74. I messed mine up when I tried to drill them out for my TRO heim setup. If you have a set that you want to get rid of, hit me up.

I was wondering if you still have the knuckles available?

I measured my input shaft. It is 1 1/16" with 10 splines. 7.5" shaft and 5.123" bearing retainer. Yeah I'm going to have to try and find a donor. I don't want to get rid of mine quite yet though. I have a fair amount invested into it already. My fault because I never thought to measure the front...

Hey thanks! This does help. After rechecking from the center of the bolt holes, this looks to be a perfect match! Now I just have to figure out if the bearing race and the part of the plate that inserts into the tranny is the same. Would you be able to measure two last things for me Langester...

Well thanks for the welcome. So the front bearing retainer plates are definately not interchangeable for future reference. The 6 cylinder transmission has a roller bearing for the front shaft while the NP435 is a taper bearing. No luck there.:p If anyone has a spare NP435 sitting around...

I am currently installing a NP435 into my 74 with the 200. I ran across an interesting situation with the input shaft on the NP435. From the information I can find, the Ford and GM versions of the NP435 had a 6.5 in front input shaft with 10 splines. The front bearing retainer plate on Ford were...

That's a great looking picture!!

He couldn't air down too much. He doesn't have beadlocks after all. Better to take that rock head on with some air.