Search results

Pulling the belt all the way out of retractor...need the measured length from end of metal clasp to pivot center of retractor. Approx will be close enough.

Have a 68 Bronco. OEM FRONT SEAT BELTS: Does anyone out there have the full extended measured length of retractor belt side and measured length of the buckle strap side ? Also need measured lengths of rear seat belts. I believe total lengths are around 74 inches. Need separate measured...

I am interested in the Tailgate side seal retainers, new wall horse, wild horses 9097, - 20.00 shipping to GA 30572

re: tach Thanks for the picture of the Sun Super Tach II. This may help to some extent. The Tach that I have is the earlier version. It is a Sun Super Tach RPM. This tach has a metal meter case and circuit board is in the meter. I need information on that model. Thanks Again

No, this one does not have any switches or loops of wire. You are probably thinking of the ones that were the later versions that had the plastic covers. You can go to the links for a diagram and picture of the Tachometer. [img=http://s20.postimage.org/bs2d9ktzt/Sun_Tach_Diagram.jpg]...

I have a really nice Sun Super Tach 8000 RPM blue line ST810 4 cyl. tachometer that I would like to use on my 68 bronco V8 302 engine. The tach has the solid state electronics in the meter itself unlike the earlier Sun tachs which had a separate sender box. I understand that the tach will work...

I have installed Saginaw power steering pump and a GM Delphi steering box on 68 Bronco. Question: Can I use Bronco stock pressure hose on this configuration ? Steering box is early style... non-metric fittings. Need adapter fitting sizes. Any help would be greatly appreciated.

I have a 68 bronco dana 20 transfer case that has a 1.25" diameter Intermediate shaft. The shaft needs to be replaced. Can anyone tell me if a dana 18 or jeep dana 20 1.25" shaft will work as a replacement ? From the pictures I have seen of the shafts...the dana 18 shaft looks the same but...

Thanks for the info on master cylinder. This helps out alot.

I recently purchased a Used Brake vacuum booster and mounting bracket for my 68 bronco off Ebay. It was missing the master cylinder. I believe the bracket and booster is an 8 inch double diaphram type sold by Tom's Bronco. My braking system is factory drum (F) and drum (R). I am looking for a...

I recently purchased a Used Brake vacuum booster and mounting bracket for my 68 bronco off Ebay. It was missing the master cylinder. I believe the bracket and booster is an 8 inch double diaphram type sold by Tom's Bronco. My braking system is factory drum (F) and drum (R). I am looking for a...

The valve I have was stuck and would not allow the warning brake indicator to work. Last nite I took it apart and got it to work. I am going to try it out for a while and see what happens. I will get back with you if it doesn't work. Thanks again

Maybe I am calling it the wrong thing. The Ford parts manual calls it the Brake Pressure Differential Valve. It works the brake warning light switch. Mounts on the drivers side frame just under upper front brake bracket. It is probably what is called the H block as it sort of looks like an H.

Need a good used original drum brake proportioning valve for 68 Bronco. Ford part C8TZ-2B257-N stamped valve body.