It doesn't look at stout as I'd want for any serious towing, but if you're just going 3 miles and plan to take it easy you should get by OK. However I wouldn't weld the bumper to the frame. I wouldn't be surprised if that bumper gets bent, either from hitting a big pothole while towing or just getting a little too friendly in a parking lot. I'd want to be able to remove it more easily if/when it needs repair.
When I (over)built my front bumper / tow bar setup I made some big solid pieces that went about 10" back into each frame rail. These "bumper mounts" were drilled and tapped for four 1/2" grade 8 bolts (2 coming up through the bottom of the frame rail, two coming in from the side). These mounts were cut down to be D-ring mounts that stick through holes I cut in the bumper, which is welded to the mounts. So the only thing the bumper does is add some stability to the frame horns. The tow bar is attached directly to the D-ring mounts which are the pieces bolted into the frame.
I built that for flat-towing across the country and I've put over 10,000 miles on it. It's definitely overkill if you just need something for a one-time 3 mile tow.