31 spline yukons for small bearing axles

[OX1]

Yukon make a kit and/or can you get 31 spline yukons without the tapered bearing and retainer set?

 

[OX1]

Dug though Yukons site and found this, but only the
passenger side. Have an E-mail into Mike @ Complete to
see if there is a matching side to it?? I know others sell
the 31 spline small bearing axles, but not @ yukon prices.

YA F9-31-32.87 [21207]
9" FORD 31spl EARLY PASS w/SMALL
BRG(RW207)(25.5"->32.87"CUT2LTH

http://yukonaxle.com/ProductDetails.aspx?ProdID=2174

 

[bmc69]

Answering yr own post is one sure way to get that post count up. Right Joe?

 

[OX1]

Answering yr own post is one sure way to get that post count up. Right Joe?

Just for histrorical purposes of course.

 

[BUCKETOBOLTS]

There is a conversion bearing with the small bearing OD and the big bearing ID for the 31 spline axles. I cannot find where I had wrote the # down at. I have also seen this bearing on Dutchman axles site.

 

[OX1]

Dug though Yukons site and found this, but only the
passenger side. Have an E-mail into Mike @ Complete to
see if there is a matching side to it?? I know others sell
the 31 spline small bearing axles, but not @ yukon prices.

YA F9-31-32.87 [21207]
9" FORD 31spl EARLY PASS w/SMALL
BRG(RW207)(25.5"->32.87"CUT2LTH

http://yukonaxle.com/ProductDetails.aspx?ProdID=2174

Turns out this shaft above is 5 on 4.5, so nogo. I have seen the conversion bearing, but was wondering if yukon made 31 spline specifically for small bearing, allowing use of the stock small bearing. Other companies sell them, so it must be able to be done (unless all the other companies also use this conversion bearing), but their prices are near double that of yukon.