• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

73 Auto Steering Column rebuild

miket

New Member
Joined
Apr 18, 2013
Messages
39
Loc.
Buckeye
My steering column finally went out a couple of months back when it wouldn't shift into or out of any gear. I bought a rebuild kit and pulled the column. Since tearing it apart this weekend, I have ran into some odd things I just can't pin point. The first is, there wasn't a snap ring of any kind on the steering shaft....I had the bearing, spring and a steering wheel mount hub that was on the splined shaft. Upon putting everything back together, I can't seem to find a way to secure the whole assembly together without some sort of snap ring. I noticed there weren't any grooves cut into the steering shaft for a snap ring to sit into so, without any detailed pictures of this available, I would like to know where on the shaft the snap ring sits? Was there ever a version that used any means to secure everything together? :cry:

I will see about posting some pictures of what I am talking about.
 
OP
OP
M

miket

New Member
Joined
Apr 18, 2013
Messages
39
Loc.
Buckeye
Here are some pictures...one is of the shaft....the other is the steering wheel hub/spring/nut.

Right below the end of the splines there is a recess but that is covered by the wheel adapter...it tapers up to a larger diameter for the hub. The snap ring would have to sit much farther down to keep everything tight.





 

bronconut73

Bronco Guru
Joined
Aug 7, 2012
Messages
9,919
You have to have some one push on the wheel from inside while you slip the clamp onto the shaft while eveything is snug. The clamp will keep it all together.
Jim Creel has a nice video of this on YouTube.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
I had one of those odd ball '73 only columns. No snap ring. As mentioned, the clamp at the bottom keeps preload on the bearings and all the spacing correct. I even went so far as to cut the shark fin off the old shift collar and graft it onto the new collar to keep the '73 look. Didn't like that loose pointer just hanging out in space look.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
Last edited:
OP
OP
M

miket

New Member
Joined
Apr 18, 2013
Messages
39
Loc.
Buckeye
I FIGURED IT OUT.

There is a clamp at the rag joint end of the shaft that provides the preload...as long as it is set properly. It was loose before I pulled the steering column apart. Thanks.;D;D;D;D
 

Boss Hugg

Contributor
Bronco Guru
Joined
Jun 8, 2010
Messages
2,213
Ok you experienced 73 column rebuilders, how do you put a new lower bearing in?
 
Top