73 Bronco SOLD thanks guys

[66Gasgrill]

I've got a 73 for sale that I need gone. I posted a few months back and got very little intrest so here goes.

73 Bronco

302 runs and idles well but smokes a little i think it needs valve seals but I did not tear into it that far. Has a new Dizy, cap, rotor, plugs, wires, coil, fuel pump, Master cylinder, starter, and solinoind. I also rebuilt the carb.

3spd on the column shifts fine but tries to jump out of reverse

T-case and hubs work fine

D-44 9" w 3.50 opens drum brakes

I did some work on the body and then lost intrest. I replaced both front floor pans, patched the drivers side kick panel and replaced all 4 of the patch panels around the wheel wells. the tub is not in bad shape but it's not in good shape either. The doors and tail gate are pretty bad as is the lift gate. Top itself is in pretty good shape with only a small dent over the drivers front corner.

It does run drive and stop pretty well but I would recomend trailering it if you will travel very far

Perfect platform for a trail rig as is or put a little more in it and have a nice street truck.

 

[66Gasgrill]

I need this gone guys make me an offer. Thanks;D

 

[sprdv1]

Travis, Read your write up in a back issue of Bronco Driver I got a little while back. "very nice" Made the cover even. ;D

BTT for ya..!

 

[66Gasgrill]

Thanks;D ;D

 

[66Gasgrill]

How About $1,700.00 Anyone?:?

 

[texsurf21]

Are you willing to ship to CA? If so I might be interested. Do you have more pics you could send me? How is the frame?

Send pics to texsurf21@hotmail.com

Thanks,

Aaron

 

[66Gasgrill]

I could probably get it to a transport depot but you would have to arrange it and pay for it I had a guy ship one to texas a couple years ago but that was before fuel went up. If I remember we took it to Knoxville to the transport company.


Been a while since I have been under it but I thinks the frame was pretty solid. I will check for sure after while. I'll also get you some more pics. Thanks.

 

[texsurf21]

Email me your number so we can talk.

Thanks,

Aaron

 

[66Gasgrill]

E-mail sent

 

[70BRONCOGURL43]

How are the inner rear quarters, door posts and rear bed floor? Can you send me your number so hopefully I can come look at this EB. I am in MIlls River.

 

[66Gasgrill]

Rear floor is in good shape as well as the rear inners. Both door post are rusted where the lower hinge bolts easy patch but would need to be replaced to be done right. Pass striker is good drivers is bad. I'll send you a PM.

 

[66Gasgrill]

well I can't send you a PM Shoot me an E-mail Rt3_454_98@yahoo.com

 

[jeepryder95]

bronco

pm sent !!!!!!!!!!

 

[gonefishin9335]

is this thing still for sale?

 

[66Gasgrill]

still for sale come get it;D

 

[66Gasgrill]

come on guys somebody buy it. I'm getting married tomorrow and could use the cash. Please;D