Aluminum Wheel Spacers

[Madgyver]

Are they any good?
I heard stories of them coming apart while driving and heard stories of poeple using them with great success.

I need at least 1 1/4"-1 1/2" of the reliable ones.
Anyone got recomendations or links?

 

[Ryans71]

I got a set of 1" spacers off of ebay. They're 6061-T651 billet with new studs. Have only ran them about 50 miles or so and haven't taken them offroad yet.

I searched this forum and found quite a few folks that had used them. I would use the machined ones over the thinner cast ones.

Ryan.

 

[Madgyver]

I got a set of 1" spacers off of ebay. They're 6061-T651 billet with new studs. Have only ran them about 50 miles or so and haven't taken them offroad yet.

I searched this forum and found quite a few folks that had used them. I would use the machined ones over the thinner cast ones.

Ryan.

Did you have to cut down the existing studs for the 1" spacers to work?

I check the studs on both the front and rear and they measured out to be a 1-1/4" long.

 

[Ryans71]

Yes. I ground them down a bit.

Ryan.

 

[broncomanbrad]

Wild Horses sells a good one. http://www.wildhorses4x4.com/18.asp

I haven't bought mine yet but they appear to be the exact ones that I plan on getting. If you look you can find quality ones on ebay. Just make sure they are good quality aluminum. In the back of 4 Wheeler mags there are ads for them too.