• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

BCB steering stiffener install

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
The schematic I found for this kit doesn't really specify how this should be installed so I thought I'd share how I recently installed one.

First step is to knock out the existing sleeves inside the frame.
IMAG2144.jpg


Next, chamfer one end of the new sleeves so they will sit flush inside the frame.
IMAG2145_1_.jpg


I then opened up the existing hole with a uni-bit until the sleeve fits through.
IMAG2149.jpg


IMAG2148.jpg


IMAG2147.jpg


Next, insure that the sleeves sit nicely in the frame and that your bolts will run through. The frame has some ridges inside from where the two halves of the boxed frame overlap. This is the reason for the chamfer on the tube.
IMAG2151.JPG


Next, I leave the bolts inserted from the steering box side, and weld in the sleeves.
IMAG2152.jpg


I then made some weld washers, and welded them on over the new crush sleeves.
IMAG2154.jpg


Finally, weld on the frame reinforcement plate. Take your time each step to insure that all your holes line up as best as you can. There is a good chance that you will have to chase your holes with a 1/2" drill bit to insure that your bolts will pass through the new sleeves, stiffening plate, and weld washers. Clean it up and paint it.
IMAG2153.jpg
 
Last edited:

68rustbucket

Full Member
Joined
May 1, 2006
Messages
226
Loc.
San Marcos,TX
Nice! It looks like your doing this upgrade before you crack the frame. I know a few of us that waited until after to plate the frame.
 
Top