• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Body work challenge

Dbarnes72

Sr. Member
Joined
Mar 18, 2009
Messages
643
Loc.
Eastern Wa.
I've finished up the drivetrain and getting ready to tackle the bodywork. Aside from typical floor replacements I have this extra challenge....both sides in front of the rear tires are hosed on the lower quarter panels. I may learn how to shrink metal before this is over. Any suggestions?
 

Attachments

  • Fender1.jpg
    Fender1.jpg
    101.9 KB · Views: 137
  • Fender2.jpg
    Fender2.jpg
    75.3 KB · Views: 146
  • Fender3.jpg
    Fender3.jpg
    62.9 KB · Views: 111

Broncmeister

Sr. Member
Joined
Sep 26, 2002
Messages
801
you could you cut out the lower quarters and replace them with new skins from one of the vendors. That's what I'm doing on project #2
 

ehumaui

Sr. Member
Joined
Apr 17, 2004
Messages
913
X2 on that, depends on what end product you want. I have done the replacement lower quarter panels on two trucks. If you were closer, I have the cut outs from my 74. It's almost the entire lower quarter, un cut stock.

Rc
 
OP
OP
Dbarnes72

Dbarnes72

Sr. Member
Joined
Mar 18, 2009
Messages
643
Loc.
Eastern Wa.
I'm putting flares back on it. I just don't want the pound of Bondo in there if I can help it. I toyed with the idea of going LUBR on it but I think for this one I'll keep it simple. I'd be happy to just get it evened back out but it's got a heckuva curl to it. Anybody got one of the braces that go in that position? Just cut out the #1 brace with my air chisel. I love that thing!
 

Rustytruck

Bronco Guru
Joined
Feb 24, 2002
Messages
10,872
After you pound it flat and if the metal stretch is too much before you go replacing metal take a saber saw with a fine blade and cut a single slice into the stretched area. cut from the wheel opening through the center of the stretched area. Now take your mig and weld up the cut starting from the center to the wheel opening. weld an inch and let it cool off then weld another inch. Keep going until you reach the wheel opening. This will pull it in. do not hammer out the excess weld just cut the top off with a cutting wheel in your grinder this way it wont over heat the metal while removing the excess weld. then use a 36 grit wheel to smooth the area for finish body work.
 
Top