• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Bronco Design hood hinge

gearida

Bronco Guru
Joined
Jun 8, 2007
Messages
1,428
Loc.
Newburgh, IN
I have a new hood, it has caused me to redo the air cleaner, due to I side clearance. Even though it is a mid rise hood the interior panel of the two piece fiberglass hood is not raised. But now I am looking at the hinge fitment now. The interior panel doesn't allow a nut n the back side or inside without cutting out a large hole for access. So I am thinking of a nut insert which will expand in the hole from the rear or outer edge. Has anyone purchased this hood with the two layers? I really don't like thinking I will cut a hole which will allow water between the two panels. I cut out the vents near the windshield where I may try putting sealer in between the upper and lower panels. What do you guys think?
 

01JLH

Sr. Member
Joined
Sep 3, 2007
Messages
392
Mike put metal in the area where the hinge attaches. You just mark the holes and drill and tap to bolt up the hinge. Did mine and it worked like a charm.
 
Top