Community
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Build thread U13FL773644
- Thread starter tk1218
- Start date
nboost
Jr. Member
So when are you going to sell it?
OP
OP
tk1218
Bronco Guru
Going to list it shortly
OP
OP
tk1218
Bronco Guru
Engine Compartment
Ok, have been trying to sell it, but I guess the market is a buyers market right now. I decided to fix a couple other things and then I might store it for a while. I built alittle storage building in my back yard over thanksgiving.
I pulled the engine and cleaned and painted the engine compartment. Went ahead and changed out the solinoid, regulator, ignition switch and key cylinder because I was having some weirdness on start up. Works great now. As for the engine, I replaced the timing chain, water pump and replaced the gaskets on the oil pan and valve cover.
Also removed the custom front bumper and verified that the frame vin and the kick panel vin match.
And now, the cobra build begins (see last 2 pics)
Ok, have been trying to sell it, but I guess the market is a buyers market right now. I decided to fix a couple other things and then I might store it for a while. I built alittle storage building in my back yard over thanksgiving.
I pulled the engine and cleaned and painted the engine compartment. Went ahead and changed out the solinoid, regulator, ignition switch and key cylinder because I was having some weirdness on start up. Works great now. As for the engine, I replaced the timing chain, water pump and replaced the gaskets on the oil pan and valve cover.
Also removed the custom front bumper and verified that the frame vin and the kick panel vin match.
And now, the cobra build begins (see last 2 pics)
Attachments
Last edited:
