• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Centech harness - hazards/flashers

JWMcCrary

Contributor
Bronco Guru
Joined
Oct 14, 2004
Messages
5,001
Does the wiring for the hazard lights (flashers) need to be connected for the turn signals to work? Hoping those wires can be heat shrinked and tied off under the dash, if not can you connect it just using a rocker switch? Not in front of it right now but seems like there is about 5 wires going to that switch.
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
Centech has duplicate wiring, so the hazards can work with the dash switch or the switch on the steering column... depending which one you have.

If you have the column switch, then just heat shrink over the spade connectors and tie them back into the harness. If you want to use a rocker, instead of the factory rocker switch, (no column switch) you can if you can find a rocker switch that is the same as the factory pull switch.
 
OP
OP
JWMcCrary

JWMcCrary

Contributor
Bronco Guru
Joined
Oct 14, 2004
Messages
5,001
I realize there is duplicate wiring, was wondering if it could be left disconnected at both places and not have any bearing on the turn signals. I just found a thread that said the flasher switch shorts all the wires connected to it together to make the hazards work, if that's the case then I think I should be fine just tying them off for now.
 
Top