• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

chevy disk brake with 68 master cly

muddog899

Jr. Member
Joined
Mar 4, 2010
Messages
68
ok I have all ready did the conversion and i know i will have a soft brake pedal but it will go all the way to the floor when i push on it I have blead the brakes with a presure bleader at 20 PSI both I am not sure if it is typical for the master to act that way. so any help would help %)
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Shouldnt go all the way to the floor. You either still have some air in the system or the seals in the MC are shot. Do you get a better pedal with 2 or more quick pumps? At some point it should get enough fluid in the system to give at least some pedal. If not I'd say the MC is bad.
 

Johnny@WildHorses

New Member
Joined
Sep 24, 2007
Messages
3
Loc.
California
A real comman problem we see here is that people will mount the calipers with the bleeder screws facing down, so make sure the bleeder screws are facing up. You might want to bench bleed the M/C if you haven't done so already. If all that is correct and you don't have air in the lines, I also would say it's the master cylinder. And if that brake system is with the floating caliper make sure you grind down the the outside of the bolt stop at the knuckle so the caliper pass by with no interference.
Johnny,
 
OP
OP
M

muddog899

Jr. Member
Joined
Mar 4, 2010
Messages
68
well I did bench bled the master and I also gravity bled them along with pressure bledder and yes my calipers have the bleeder screws facing up I did grind the knucle for the clearance I am thinking it is the master also because it wont pump up to a firm pedal after pumping the brake pedal:mad:
 
Top