Custom track bar bracket by migs –Impressive!!

[JSmall]

I started a thread asking about track bar clearance issues with a 3.5” lift. Brian commented on that thread and mentioned that we have close to the same setup and that he made his own riser. After reviewing his thread and being very impressed with his craftsmanship, I asked him if he could build me one.

He asked for a few measurements and then went to work. I have a 76 D44 so there are some differences. He went out of his way to find a disk D44 to test the bracket on to make sure it would work when I got it. From the time I asked him to build me the bracket to the time he shipped it was less than a week. I got the bracket last night and I am very impressed with his work. It was packaged better than fine china ;D

Anyway, just thought I would give a shout out and a big THANK YOU to a member of this site.

 

[fatboy]

He does do very nice work. Here is the axle he used to test fit. ;D

 

[JSmall]

Looks like you guys have all the fun ;D Hope he bought you a beer

 

[broncoitis]

Nice job MIGS! Like the design a lot. Sturdy and double shear on the bolt the way that it should be to begin with!

 

[Slednut10]

Brian's fab skills are unbelievable! We are lucky to have him in this neck of the woods!

 

[TTTGOWYO]

wow.. niuce stuff!

 

[tasker]

He is a talented dude!!!

 

[toddz69]

Very nice work! Double shear and lightening holes!

Todd Z.

 

[JSmall]

I'm going to gain 5 HP from the speed holes

 

[golfobx]

He built me some pivot mounts for cage frame tie in's. They were finished in 10 hours and at my house 3 days after we talked. Exactly what I needed and top notch work.

 

[bronconut73]

That riser is bitchin'.

He asked for measurements?

 

[JSmall]

That riser is bitchin'.

He asked for measurements?

Stock track bar bracket width just to verify.

 

[Crush]

How bout some installed pics

 

[badmuttstang]

Man you were telling me about this last week and it looks great. It'll definitely make things easier after the nw round up when you do your lift.

 

[JSmall]

How bout some installed pics

Just got it so no install pics. Brian has a few in his build thread.

http://classicbroncos.com/forums/showthread.php?t=198510&page=30

 

[Apogee]

MIGS...it looks like it should be TIGS. That's some clean booty-fab.

 

[Crawdad]

We'll get it on there and let's see if it works! I might need one for my 77 front axle and 3.5" springs.

 

[JSmall]

We'll get it on there and let's see if it works! I might need one for my 77 front axle and 3.5" springs.

I would like to say I'm starting now. I'm holding off on the suspension until I get back from the NW Roundup. I have a few suspension and steering upgrades to do at the same time and I don't want to jeopardize my Bronco not making it for the 2nd year in a row. Should be starting at the end of August.

 

[broncoitis]

MIGS...it looks like it should be TIGS. That's some clean booty-fab.

Too funny! Was thinking the same thing. He is evolving from migs to tigs for sure.

 

[dave67fd]

He's quite the talented lad and we can only be blessed to have a piece of his artwork on our rigs.