• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Driver Side Seat

robbgorr

New Member
Joined
Feb 15, 2014
Messages
4
I'm reupholstering my seats and am having trouble removing the driver side seat. There are 4 bolts that hold the sliding bracket to the floor but I can't get to the bolt heads underneath the truck because the auxiliary gas tank is in the way. Do I need to remove the gas tank, or is there an easier way?

Thanks!
 

CopperRanger

Bronco Guru
Joined
Sep 26, 2007
Messages
1,796
I think there are nuts welded to the floor section, you should be able to unbolt them from the top, unless somebody did a modification.
 
OP
OP
R

robbgorr

New Member
Joined
Feb 15, 2014
Messages
4
Not welded

It makes sense that the original design had bolts welded... It seems the previous owner made a modification. The bolt and nut are spinning when I try to unscrew from the top. Any other suggestions?
 

thegreatjustino

Contributor
Red Head Grease Monkey
Joined
Jan 23, 2002
Messages
16,291
Loc.
Stockton, CA
Cut the heads off. Even if you take out the tank, there's no guarantee you'll be able to access the other side to get a wrench on it.

Of course the problem with cutting the heads off is that you'll need to figure out how to re-mount the seats once they're ready to put back in.
 

akafrankcastle

Sr. Member
Joined
Dec 8, 2002
Messages
876
Loc.
Kansas City
Using a flat blade screw driver, apply upward pressure on the underside of the bolt head while you slowly attempt to loosen it. Apply PBlaster, or an equivalent lubricant/penetrating oil, beforehand to make things easier. If you are successful, you will still need to remove the tank to put the seats back in. But at least you will have the seats removed for reupholstery.
 

Buckeye Rob

Jr. Member
Joined
Sep 7, 2013
Messages
100
Loc.
Hurst, TX
If the seat is in the factory location, the front nuts should be hidden inside a brace from my experience on my 75. The rear should not be. I'd drop the tank. Good time to inspect the tank anyway. I had to drop my tank to seal the edges of the new floor pans the PO put in but I went to a 23 gal rear tank and ditched the aux tank when I did it.
 

bteutsch

Sr. Member
Joined
Jan 11, 2009
Messages
875
Drop the tank, not a big project but you will get full access to the seat bolt.
 
OP
OP
R

robbgorr

New Member
Joined
Feb 15, 2014
Messages
4
Thanks...

Thanks for the help.... I think I'll try to apply upward pressure and carefully remove the nut, then tape the bolt in place after removing the seat slider bracket. If I'm careful enough, I can reupholster, then slide the bracing back over the bolt. I'll have to drop the tank if any of the bolts fall. Any last words of advice?
 

okie4570

Contributor
Bronco Guru
Joined
Jul 16, 2012
Messages
9,537
Loc.
NW OK
I used a air cutter to remove the back left bolt, used a piece of wire to sweep the fallen peice off of the tank. Replaced it with an L shaped bolt. My truck is not original nor a show truck either though;)
 
Top