whitts end
New Member
- Joined
- Jul 12, 2007
- Messages
- 12
So I finally got my late model 5.0 to start and run but when I go to put it in gear(its an automatic C4) it dies or backfires and dies. So I rolled it out in the street and gave it throttle enough to get it to drive but it shifted all weird and really didnt feel right. Both the tranny and transfur case were re-built about 3 years ago and have since been filled with fluids and ran. Then the Bronc just died, it stalled out not to start again so I pushed it back to the garage to find one of the 15 amp fusses(1 of 2) on the aftermarket Ron Francis EFI harness I have was blown so I replaced it only to watch it blow as soon as I turned the ignition on!! What the Hell???!! It's been starting up fine this whole week! I bypassed the neutral safety switch so that may have something to do with it and I know my shift linkage needs adjusting but how? I am lost now and eager to drive this restoration of 5 years. PLEASE HELP!!! especially if you have delt with a Ron Francis harness.
so close but yet so far!
Thanks as always.....
so close but yet so far!
Thanks as always.....











