Factory Sway Bar

[BlaneyE]

I’m looking to install my factory sway bar but can’t seem to find U-Bolts to mount it. Does anybody know the sizes of the two so I can order them?

 

[Oldtimer]

The MPC does not have a listing or description of U-bolts.
The nuts for U-bolts are 7/16-14 Grade 5 flange locking nuts.
Measure the diameter of the D44 axle tube.
You may be able to find a 7/16 U-bolt to fit?

7/16 inch Diameter Round U-Bolt - Dsuban Spring

7/16 inch Diameter Round U-Bolt is Custom Bent. Pricing includes Extra Deep Nuts and Hardened Thick U-bolt Washers. Grade 5 material.

dsuban.com

 

[Jwredneck]

I just pulled mine yesterday. I'll try take some pictures with a tape measure when I get home this afternoon.

 

[BlaneyE]

I just pulled mine yesterday. I'll try take some pictures with a tape measure when I get home this afternoon.

That would be much appreciated. I climbed under today and attempted to get an accurate measurement of the axle itself. Looks like 2 3/4 for the driver’s and 3 inch for the driver’s but it was difficult to get exact

 

[.94 OR]

Can you measure the hole spacing in the mounting flange?
It might be a tad wider than the diameter of the axle tube.

 

[Jwredneck]

7/16-14 threads.

 

[BlaneyE]

7/16-14 threads.
View attachment 945315 View attachment 945316 View attachment 945317 View attachment 945318

Awesome thank you! Looks like my measurements were off