70_Steve
Old Guy
- Joined
- Dec 13, 2002
- Messages
- 8,317
Yes.Exactly!
Community
Buy / Sell
Bronco Tech
Fuel Tank Access Plate
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Fan too high for shroud to fit - Engine mounts?
- Thread starter Yellow75
- Start date
OP
OP
Yellow75
Bronco Guru
LMAO.. Fuc* me.. I rebuilt the damn transfercase too had the whole damn thing apart. Never knew. The joys of deciphering what the p/o did.
I will say walking back into the garage and seeing it again after 5 years sure turned back the clock. Glad to be back on this forum again. Awesome seeing and remembering all of the "old" names too. This place fkn rocks.
Maybe now i'll do something about the rusty floorboards, maako paint job, Oh.. crap.. Thought the harley forums were bad
I will say walking back into the garage and seeing it again after 5 years sure turned back the clock. Glad to be back on this forum again. Awesome seeing and remembering all of the "old" names too. This place fkn rocks.
Maybe now i'll do something about the rusty floorboards, maako paint job, Oh.. crap.. Thought the harley forums were bad
OP
OP
Yellow75
Bronco Guru
Got the mounts flipped around. Wasn't too painful. Found the p/o used some aluminum spacers to raise the crossmember up to "useable" level. However... Now the cobbled/welded shift linkage isn't working right. Too short/wrong angle or something. Got it close but a nudge will bump it out of park. Going to order up a new one tonight to fix that.
Troubleshooting the park switch on the trans I seem to have made the blinkers and heater fan not work though.. Headlight works, Gauge lights aren't coming on. Didn't pinch any wires that I can tell..
Can the voltage regulator cause these problems? It seemed pretty warm when I checked it.
Troubleshooting the park switch on the trans I seem to have made the blinkers and heater fan not work though.. Headlight works, Gauge lights aren't coming on. Didn't pinch any wires that I can tell..
Can the voltage regulator cause these problems? It seemed pretty warm when I checked it.
Similar threads
