Orange Crush
Bronco Guru
This is the best option IMO, but if this is not the route you want to take, I would think you could use the old flares as templates to mark the position of the holes on the new ones, drill, install, done.
Community
Buy / Sell
Bronco Tech
Fuel Tank Access Plate
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Fender Flare Question
- Thread starter Annapolis76EB
- Start date
This is the best option IMO, but if this is not the route you want to take, I would think you could use the old flares as templates to mark the position of the holes on the new ones, drill, install, done.
