Floor hole locations for AX15 and transfer case

[MR_Moto]

Hi;

I'm having my 72 restored, and new floors are being welded in. I'm also installing a new AX15 at the same time. When my body guy replaced the floors, he tossed the old metal. Long story short, I need a floor cutting template for the AX15 shifter, as well as the hole location for the transfer case T shifter. Please note that I'm not using a body lift, if that matters.

I'm new to this forum so any help would be greatly appreciated.

Thanks! -Mark

 

[sticknstring]

If you shoot me a cell phone number, I could text you photos of mine, but it has twin sticks too.

 

[JB Fab]

You could use the ring from our NVAX boot.......

 

[sticknstring]

This is what I used inside.

 

[ngsd]

You could use the ring from our NVAX boot.......

Looks great, do you have measurements on where to place the template for best location?

 

[JFO]

I’m considering installing the AX15 with my 302 and without a body lift as well. I’m building from the frame up. How did your install go without a lift and what is your recommendation now that you’ve done it; good without a body lift or not?

Thanks!