Gove Box Modification

[driller]

Does anyone know where I can find the write up by Jon Hanna on how to do the flip flop glove box door modification.

 

[Tito]

http://classicbroncos.com/rollcage.shtml

Its pretty cool, havent decided if I will do it yet.

 

[eds66bronco]

this one is very simple and allows you to go back to stock. only took me a couple hours start to finish.

http://classicbroncos.com/glove_box_hinge.shtml

 

[Cooter_76]

Here's a slick one from the BroncOhio website.

Or you could do what my PO did...crush the roll bar with a BFH so that the glovebox door clears. %)

 

[KJHill]

Or you can do what I did :-X cut about 1" off the far right of the door... I shouldn't drink & work on the Bronco so much... :'( Seemed like the thing to do at the time.

 

[Madgyver]

There is a bunch of pics on this thread..........................

 

[Hauq]

I took the glove box door off and put a net up in its place.

 

[blazinchuck]

I cut the speaker and glove box together , then cut the 2 apart and swapped them. Not too bad, but required some body work. I wish I had known about the sliding hinge...oh well ;D

 

[HotWheels]

What's a "Gov"? Perhaps the "Gov"enator?

Have you considerd the tuffy "Gov" box? I love mine (can actually secure stuff in) and it clears roll bars.

hth,

Mick

 

[7d1]

I did this one:

 

[Tito]

7d1...Me likey...that is pretty cool, I think worthy of a tech article Write it up man. Write it up.

 

[Madgyver]

7d1...Me likey...that is pretty cool, I think worthy of a tech article Write it up man. Write it up.

Someone already did it..............

 

[SaddleUp]

Here's a slick one from the BroncOhio website.

Or you could do what my PO did...crush the roll bar with a BFH so that the glovebox door clears. %)

I did this except that I also applied heat at the same time. Made a nice flat area on the rollbar next to the glove box so it would clear. I've since won a Tuffy one in a raffle so the flat spot is meaningless now.

 

[7d1]

I did it according to the wright up to the left. Took about 1/2 hour.

 

[bronco977]

I did the BroncOhio mod- it was easy and quick!

 

[eds66bronco]

I did it according to the wright up to the left. Took about 1/2 hour.

nice job! glad some people are getting some use out of the tech article