Guages and drivers signal not working

[TheFlyingFist]

Hi,

My oil pressure, gas, temp gauges, left hand signal and left brake light haven't been working for a while. I've been thinking about replacing my stock wiring but wanted to see if there were alternative fixes before I decide to buy a new wiring harness.

I haven't been able to take long trips w/o knowing how much gas I have in either tanks.

Thanks!

 

[oleguy74]

bulb.they use the same filament.as for gauges,disc temp sender wire from sender.connect voltmeter to wire and turn ign switch to accessory po.tou should get 4-6 volts pulsing.if not,iver on back of cluster may be bad.if you turn headlites on and cluste ites com on ground to cluster is ok.if not may be a bad ground .