• Be EXTREMELY cautious if someone offers to buy your Bronco for more than your asking price and sight unseen. ESPECIALLY if the buyer is overseas. It's probably a scam.

    Discuss it more here:
    http://classicbroncos.com/forums/showthread.php?p=514932
  • The Classifieds forum is a place to buy and sell, not an open forum for people to give their opinions on Bronco values. Unless the seller specifically asks for help on pricing, please don't critique quality or asking price. If you're not interested then move on.

    Thanks!
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

NM Hammerform for lower tailgate repair

Status
Not open for further replies.

canary28

Jr. Member
Joined
Oct 19, 2007
Messages
51
I made a hammerform out of hard maple to make a new bottom third of my tailgate (from the spot-welded seam below the FORD letters to the bottom of the tailgate). It's roughly tear-drop shaped in cross-section (like the original panel) and ca. 6 feet long. Long enough to make the whole panel in one piece.
It worked well, but I don't plan on needing it again. Great for somebody who has more time than money and some metalworking skill.
I'll post or send a pic to anybody who's interested.
I don't want to ship (would probably cost more than a new equivalent patch panel from LMC or JBG), but can meet somewhere around the east side of Albuquerque if you're interested.
 
Status
Not open for further replies.
Top