Hood Pins

[Johnnyb]

I am installing Wild Horses hood pins on the original hood and I am wondering how I am going to hold the nuts to tighten the screws?
Problem is that there is a plate below the hood and the bushing that goes through the hood also goes through the plate. One of the nuts is in an impossible place behind the bushing, between the plate and hood.

Any ideas?

THX,
JB

 

[fluffybunny]

Do you have enough room to get a boxed end wrench in there? if so, cover one side of the wrench with a piece of tape and put your nut in there.

 

[Johnnyb]

Do you have enough room to get a boxed end wrench in there? if so, cover one side of the wrench with a piece of tape and put your nut in there.

Yeah it's going to be tight. I'll give it a try.