liscense plate wiring

[Kyle.malone]

Getting to the rear of my bronco today. I have found everything that I need for the tail light buckets and got them installed and working correctly. Last bit is the liscense plate wiring. Centech only gives you one wire. The pigtail coming out of my original light houseing has two wires. One green and one red. How exactly does this get hooked up?

 

[needabronco]

The Centech wire is positive, all you need to do is ground the other wire. Use red for positive and green for ground. Also don't hardwire the license plate light if you ever plan to remove the tailgate for any reason...

 

[aaron6920]

2x, the other wire is ground.

 

[HollywoodC]

3x...just finished running my new Centech wires this weekend.

 

[Steve83]

Run the Centech wire to the insulated female side of a 2-pin flat connector at the L t/g hinge, and ground the male (exposed) side of the connector. Put the corresponding connector on the light wires. It doesn't matter which is which.