• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Lower coil spring retainers

jlake4130

Full Member
Joined
Mar 14, 2011
Messages
244
Loc.
phoenix, az
I got my full width HP 44 under my bronco this weekend and noticed the the plates that bolt to the tops of the radius arms are the exact same. What i mean is theres not a pass side and driver side plate, they are the same. And since the holes in them that are used to bolt them down are offset, one plate fits on top of the radius arm fine and the other just doesn't site right! Does anyone know what i'm talking about? Are there supposed to be pass and driver side plates? If i get the duff spring plates will they fit on both radius arms? Thanks!
 

doran4x

Contributor
Sr. Member
Joined
Dec 31, 2004
Messages
405
The coil cups are the same. They should bolt up without a problem.
 
OP
OP
jlake4130

jlake4130

Full Member
Joined
Mar 14, 2011
Messages
244
Loc.
phoenix, az
I should mention i also have the duff long arms. The lower cup has a n indention for the coil to rest in. On the pass side the indention sits facing foward of the axle. But on the driver side it sits facing the rear of the axle and it rests on the axle head unit of the duff arms. Because of this it doesn't bolt down flush. I'm guessing i need to order the duff lower spring cups too.
 
Top