Measurements needed

[Bedore09]

New to the site, Bought my 68 bronco with no floors and some hacked in rockers, I'm looking for some measurements between the front door posts and the rear door post, across the bottom and the top if anyone could help that would be great. Trying to get it straightened back out, I believe inside to inside on the bed rails is 56" does this hold true for the door posts as well? Thanks

 

[dave67fd]

See if this helps.
Quick Note:
F=floorpan
G=lower bolt which holds the side of the dash on
C, H', I'= are the outter portion of the striker post, just before the bend where the body panel begins. This should be self evident when you begin to measure!

AB-4 inches

BC-39 inches to far edge of bolt hole, not center
BD-25 inches
BE-23 inches (your measurement was 22 5/16, was that to the upper door
jam?)

BH-8 1/2 inches
BI-14 7/8 inches
BJ-27 3/4 inches

HH'-39 inches
HD-20 1/4 inches
HJ-22 1/4 inches

II'-39 inches
ID-18 3/16 inches
IJ-19 1/16 inches

FG-13 1/2 inches

 

[Bedore09]

Thanks this helped greatly in aligning up the doors, thanks, now due to the lack of floors the side of my body has a wave to it. I just need the measurement from passenger to driver sides so I can square it all up and brace it to get the floors in. Bottom post to post, and top post to post.

 

[half cab]

Couple difference members measurement in this thread .

http://classicbroncos.com/forums/showthread.php?t=248254