I need some help identifying this intake. I know it is an Offenhauser and I think it is a 6010-dp but am not sure. Any help would be appreciated. Sorry about the bad picture. It was from my cell phone and wasn't planning on posting it. Thanks
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Need Help Identifying Offenhauser Intake
- Thread starter rlwhetsel
- Start date
I need some help identifying this intake. I know it is an Offenhauser and I think it is a 6010-dp but am not sure. Any help would be appreciated. Sorry about the bad picture. It was from my cell phone and wasn't planning on posting it. Thanks
Silverhorse
Bronco Guru
I'm not sure what it is but it doesn't look like a dual plane intake. The throat of the intake looks open instead of having a divider in the opening . In other words it's more for top end than low end torque like we need. IMO you would be better off with a Edelbrock Performer or the equal.
