Dana 20 early 70's "T" shift. 4R70 transmission mated to the Dana 20 transfer. Advance Adapter between. The input shaft will sit inside 13 needle bearings that are placed on the inside of the output shaft. Does anyone know the dimensions of those needle bearings?? On a splurge I purchased a rebuilt transfer case and the guy included a bag of needle bearings. Unfortunately, I "forced" 13 of the bearings in, which resulted in 2 of them being crooked, which resulted in me not being happy, and four hours later getting them out to find 2 of them were shorter than the others and not all the bearings seemed to be the same circumference. So, this time I would like to put in the "correct" size needle bearings for the re-build. Any comments would be welcome ...... I think.











