Well I picked up a low mile NV3550 and am going to do the swap, I plan on getting TBP complete kit and will be trimming the brace on the floor and not doing the body lift.
For anyone that has done it , is there any other supplies parts I may need or should replace at this point. I would like to order as much as possible once due to shipping and duty charges.
Yea, there will be a couple of things you'll need.
-Make sure you have a clutch alignment tool. It takes an odd one with GM splines and Mopar pilot. You may have one in your kit but I'd check the size before starting.
-Buy an additional quart of the Mopar oil. Mine swallowed up both of the quarts provided in the kit without getting anywhere near full. Also, it doesn't hurt to overfill it a bit. I think I overfilled mine by 1/2 quart by filling it through the shifter hole.
-Also, I'd consider resurfacing the flywheel. It'll work a lot better with the new clutch that comes in the kit.
-This will be a good time to make sure your clutch linkage is in good shape too. It's pretty easy to replace the Z-bar bushings, adjuster, return spring, and the rubber floorboard & bellhousing boots when it's all apart.

-You'll also need a twin stick shifter if your transfer case is a "J" shift.
Be ready for a pleasant surprise! This is great mod and drives really nice.
