• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

problems reinstalling distributor

redneckrocky

Full Member
Joined
Jul 27, 2001
Messages
298
Loc.
Austin, TX
Well the new engine is finally in, hooked up and ready to go ALMOST. What is the whole process of restabing the distributor, setting the points and getting the engine running right. I know how to get the #1 to top dead center (thanks to the recent post) but other than that im lost, and so is my manual. Im a little slow sometimes so don't use big words, THANKS im ready to hear my new powerplant rumble.
 

Jeepster

Bronco Guru
Joined
Jul 13, 2001
Messages
1,507
you will want to know the firing order on the cap, find #1 on the cap, turn the Dist so that the vacuum advance is pointing toward the front (fitting it so that you can turn the Dist both ways to time), point the rotor towards # 1 post on cap. (fit cap on dist, then mark dist housing with a mark inline with #1 on the cap) drop in place, snug down with holdown. (might have to slightly jiggle crank a little to mesh the gears).
 

BwoncoHowie

C-4 Wizard
Joined
Nov 11, 2002
Messages
3,571
[quote author=jee:pster link=board=5;threadid=21760;start=0#msg167508 date=1062716386]
you will want to know the firing order on the cap, find #1 on the cap, turn the Dist so that the vacuum advance is pointing toward the front (fitting it so that you can turn the Dist both ways to time), point the rotor towards # 1 post on cap. (fit cap on dist, then mark dist housing with a mark inline with #1 on the cap) drop in place, snug down with holdown. (might have to slightly jiggle crank a little to mesh the gears).
[/quote]

Jeeptser has got he key here...
Drop the dist in with the rotor pointing toward tower #1 on the cap and the vacuum advance nipple pointing straight at the radiator. This all should be done with the engine on #1 comppression stroke. You may have to bump the engine over a little to get the oil pump drive to mesh so that the dist drops in all the way, then crank it around till you are on the timing mark #1 compression, then check to see if your dist rotor is pointing at tower #1. If not you will either have to adjust the dist timing if its close or remove and repeat the dist installation process a tooth or two in the direction you want it.

~BH
 

feitctaj

FNG
Joined
May 3, 2003
Messages
4,319
Loc.
Group W Bench
if you want go a little further , hook it all up after you are done and keep the dist bolt loose and just rotate the dist a little back and forth with everything quiet and #1 spark plug wire near to the plug. With the Key on( not long the coil will not like this for long)You can watch the arc and tell if you have been accurate ;)
 
Top