I have a ron davis 5.0 conversion rad and it up against the p side of the frame. are my mounts off ??how tihgt of a fit is it?? i measured the body off the frame its pretty even and sq maybe tweak that so it fits beter. OR is there a rad that gives me more room on that side.?? i do have a one inch body lift or how high can i move rad up befor hood and stuff is in the way?
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
ron davis rad to close for comfort p side of frame
- Thread starter mcsparks
- Start date
- Joined
- Nov 11, 2007
- Messages
- 7,896
pictures?
We cut a 4 inch piece about half way through each side of the frame on the passenger side of the radiator. This piece was rotated and welded back in the frame to give a nice notch for additional radiator clearance. I run a generic aluminum radiator and this gave finger clearance for the drain valve.
Similar threads
