70HalfCab
Full Member
Putting a stock auto column in my Bronco and am having lots of trouble with the darn roll pin that connects the shift lever to the collar. I got the shift lever in and have the roll pin in through the top and through the hole in the shift arm. Now no matter what I do I can't get the pin the rest of the way into the other side of the collar. Looking with a light I can see it is very slightly out of alignment with the bottom hole but wiggling the shift lever up down side to side etc and I can't for the life of me get it to line up the last tiny fraction of an inch. Now I can't get the darn pin out the way it came either. I'm afraid to hit it any harder with a hammer.
Any tips, tricks or ideas on how to get this roll pin in? Or out for me to start overall.
Any tips, tricks or ideas on how to get this roll pin in? Or out for me to start overall.











