SpareParts is finally going to grow up.....I'm switching to one tons. After breaking the 1/2 tons stuff too many times, the bigger axles are bought and getting ready to under go surgery.
I have D60 king pin with 4:10 gears out of a 1988 F-350 for the front and a 1979 14 bolt with 4:10 gears for the rear.
I have already started the disk conversion on the 14 bolt, a combination of Ford D60 rotors and chebby calipers with bolt on brackets. I copied the design from Jamey's axle he is building for his, I will also be shaving the bottom of the pumpkin off. This will give it about an 1 1/2 more ground clearance, probably not going to be giving much up in the rear. The pumpkin will only hang down from the axle tubes around 4" after I'm done.
Here's a couple of pics of me getting started.