Anyone know where these can be bought? Only time I've ever seen these are in the picture.
Sent from my SM-S901U using Tapatalk
Sent from my SM-S901U using Tapatalk
Community
Buy / Sell
Bronco Tech
Fuel Tank Access Plate
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Speaker enclosure
- Thread starter daddycreswell
- Start date
Nice. They're probably homemade. I've not seen any others like it.
OP
OP
I was thinking the same thing, I asked the guy that was selling the Bronco, he didn't have a clue. Said they were in it when he bought it. I might try to build some.
Sent from my SM-S901U using Tapatalk
I build a wood sub structure that covered the entire back opening. It was fairly easy to build. I added a couple "L" brackets for support and mounted it.
I then added panel covers over it. If I hadn't been adding the custom panels, the wood could have been covered with a thin sheet of metal and painted or textured.
I then added panel covers over it. If I hadn't been adding the custom panels, the wood could have been covered with a thin sheet of metal and painted or textured.
OP
OP
I'd like to see pictures of it if you have any handy.
Sent from my SM-S901U using Tapatalk
This is all I have.
OP
OP
That's cool, I used some chip board to make up some rear quarter interior panels and put a couple of speakers in them. I am thinking I might just make a custom box to fill the entire area then install speakers into it. Be another project I can add to my list.
- Joined
- Mar 8, 2007
- Messages
- 81,996
someone might make a few dollars if they prototyped and built those Looks very clean
- Joined
- Mar 8, 2007
- Messages
- 81,996
Looks awesome!!
OP
OP
Just another project to add to my list....
Those are nice. Easy fab job for someone / vendor to make and sell.Anyone know where these can be bought? Only time I've ever seen these are in the picture.
Sent from my SM-S901U using Tapatalk
