Excellent pics OX. Curious if I could tilt the motor enough to avoid the length of hole needed to slide the tranny into the bellhousing.
Also how much body lift are you running?
Did you have to move the transfer case cross member? How much?
I jacked the front of the motor up and it wasn't even close to enough. That was the smallest hole I could get away with.
No body lift, which was what made it as much of a PIA as it was.
I egged out holes that mount crossmember to frame brackets about 3/4 inch.
I also swapped thicker for thinner TC tunnel mounts, allowing
TC and tunnel to sit a bit lower. This helped clear back of TC with other body
crossmembers that normally sit jsut rearward of the TC.
It did create a problem with one of the TC shift rods, which I had to grind out a bit on the top of the crossmember to get the shift rod all the way forward.
All works great and was worth it as I in no way wanted any body lift.