• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

throw out bearing retainer clip ?

suckerpunched

Sr. Member
Joined
Aug 24, 2006
Messages
882
Is this the way this clip goes in? It fell apart before i could look at it. Better question might be, does it even need to be there?
 

Attachments

  • phpKGO5C7PM.jpg
    phpKGO5C7PM.jpg
    120.9 KB · Views: 82

COSCAG00

Sr. Member
Joined
May 16, 2011
Messages
426
I think that clip goes on the other end. It holds the shift fork to the bell housing. Show the other end of the shift fork.
 

SDlivin

Sr. Member
Joined
Feb 5, 2010
Messages
793
Loc.
San Diego
That metal wire bail retainer is what holds the clutch fork to the housing tab the fork pivots on in the middle. It's Leverage point.
if that makes sense....
 
OP
OP
suckerpunched

suckerpunched

Sr. Member
Joined
Aug 24, 2006
Messages
882
It does make sense. I was cleaning up the bell housing and that clip showed up during the process. Couldnt figure out where it came from but you guys are probably right. will look at it tomorrow.
Thanks,
Mike
 
OP
OP
suckerpunched

suckerpunched

Sr. Member
Joined
Aug 24, 2006
Messages
882
Yep you guys are right. The clip holds the fork to the bell housing pivot. kind of a no brainer when you look at it. I dont know what that says about me.
 
Last edited:

thegreatjustino

Contributor
Red Head Grease Monkey
Joined
Jan 23, 2002
Messages
16,291
Loc.
Stockton, CA
Good luck getting it back on. I have never had any luck getting them back in correctly. One of my Broncos didn't have one when I bought it, and the last clutch job I did, I gave up and left it out. Nice in theory to have something to hold the clutch fork to the pivot point, but poorly engineered from an R&R standpoint.
 
Top