torque for body mount bolts?

[RedLeg0811]

Pretty much what it says. What torque should I do the bolts at?

Thanks

 

[Dan74Bronc]

Good question.
The 1" BL kit I got from one of the vendors, I don't remember who but I think it was BC Broncos, just had the nut bottom out on the shoulder of the bolt.

 

[Pokey71]

simple question...simple answer

TIGHT!

 

[regshawn]

Tight but not to tight, and be careful with an impact gun because you can crush the body brace in pretty easily!

 

[RedLeg0811]

How tight is tight? It is hard to tell with the bushing.

 

[Vintage Steel]

General motors official procedure fro torquing bolts is as follows:
1-Tighten bolts in an even pattern until they break.
2-Back off 1/2 turn

 

[widstje]

I lost the paperwork with my bushings. Is it 35 ft-lbs? Can anyone verify?

 

[12-Pack Jeff]

I blast mine with an impact gun until tight.. I also use very large washers on the top of the floor so it doesnt pull through the body... nuff said