I came across a used trac lok unit yesterday however it will need a rebuild of the clutches. I’ve done some searching and can’t seem to find a detailed tech article or instruction guide on how to rebuild one.
I’ve never been inside of one before so I’m reaching out for some help. Are there any special tools methods I need to know about? I read some place to “soak” the clutches before install?
Are the spider gears the same in an open diff vs. a trac lok unit? If you had an open with good spider gears could you swap them out into a trac lok unit if the ones in the TL were bad? Just asking...........
Tim
I’ve never been inside of one before so I’m reaching out for some help. Are there any special tools methods I need to know about? I read some place to “soak” the clutches before install?
Are the spider gears the same in an open diff vs. a trac lok unit? If you had an open with good spider gears could you swap them out into a trac lok unit if the ones in the TL were bad? Just asking...........
Tim